This map shows the vaccine sufficiency ratio for the priority group for each and every country (the map is clickable and provides additional detail in the tooltips). It is defined as the total number of primary doses that have been administered to the total population divided by the size of the priority group in that population.
The priority group includes all seniors aged above 60 and all health workers (physicians, nurses and midwives) below 60 – the latter age cut-off to avoid double counting. For further details on the concept and measurement of the priority group, see the note on the priority group in the background section below.
Note that vaccine sufficiency for the priority group does not measure actual vaccination of the priority group.
It therefore measures, in a minimalistic way, whether the a proxy for the supply of vaccines (the total doses administered to the total population thus far) could have been sufficient to cover fully the priority group.
Like the vaccine coverage ratio, the vaccine sufficiency ratio converts the doses administered into double-dose equivalents, so that we get consistent comparisons across countries that are invariant to the mix of vaccines used. That means that doses belonging to 1-dose protocols are multiplied by 2 whereas doses belonging to 3-dose protocols are multiplied by 2/3. With this adjustment, we achieve 200 as the full coverage milestone.
Finally, the vaccine sufficiency ratio is censored at 200. Once the priority group can be fully covered with 200 adjusted shots per 100 people in the group, we consider that vaccine sufficiency (in the minimal sense of the concept) has been attained. Larger values are set at 200.
For further details on this method, check out this post and the background note below on double-dose equivalents, the global priority group and other aspects.
Pandem-ic uses the World Bank income classification as a major building block in the analysis of the impact of the pandemic.
The income classification groups countries in four buckets by per capita income levels: high-income countries (HICs), upper-middle-income countries (UMICs), lower-middle-income countries (LMICs) and low-income countries (LICs). We use the current FY2022 classification, which determines the thresholds of the buckets as follows:
See here for a dynamic visualization of how the income classification of countries has changed over time through the current FY2022 classification
A good part of this site also analyzes the pandemic by region (where we use the World Bank regional classification and the UN geo-scheme of subregions). In both cases (i.e. across income groups and regions), the universe of countries is based on the World Bank income classification. More on that in the next note.
The universe of countries on this website is determined as follows.
Note that the vaccination data is pulled from Our World in Data, which utilizes a slightly different universe of locations. In sticking with the above 196 countries and economies, we have made the following adjustments relative to the OWID universe.
For each of the above adjustments to the vaccination data, we make adjustments to the demographic data that vaccine information is related to (including population size, age structure and priority group size).
Finally, note that no adjustments are required to the totals for France as its overseas territories and dependencies are already included.
Most of the vaccine data on this site converts the doses that have been administered into "double-dose equivalents" (DDEs). That is because the vaccine landscape is diverse with different treatment protocols, Most vaccines require 2 doses but there are some that require just 1 (e.g. CanSino, Johnson & Johnson and the stand-alone version of Soberana Plus) and others that require 3 (Abdala, the combination of Soberana 2 & Soberana Plus and ZF2001). These are considered primary vaccinations which when completed result in full vaccination status - they are not boosters. Given this diversity of protocols, we would like to bring them all into a common denominator so that doses administered can be compared properly. On this site, we choose double-dose vaccines as the common denominator.
Converting into DDEs means that we multiply the number of single doses administered by 2 for a single-dose protocol and 2/3 for a three-dose protocol. For example, if a country had administered 100 doses under a single-dose protocol, we would count it as 200. Conversely, if a country had administered 300 doses under a three-dose protocol, the number of doses would be scaled down to 200. In both cases, we would achieve full vaccination at 200 DDE doses per 100 people.
Why not just sum up unadjusted doses?
That would lead to two problems:
The DDE adjustments tackles these 2 problems. Thanks to the adjustment, we can compare countries's progress regardless of the mix of vaccines they are using. We also have a common threshold of full vaccination at 200 doses per 100 people or 200%. Moreover, this threshold is invariant across countries and over time. It is a steady milestone against which progress can be evaluated.
If the DDE approach allows us to measure progress towards full vaccination, what is the difference then with alternative measures such as the share of the total population that is fully vaccinated? The answer is that the DDE approach is less demanding in terms of the data that is required. In order to calculate the full vaccination rate (the share of the total population that is fully vaccinated), we need to have timely information on whether each dose administered contributes to the start, the completion or both of a vaccination cycle (both would be the case of a single-dose protocol). The DDE approach requires information about single versus multiple dose vaccinations, but it is agnostic and therefore less demanding about whether a dose of a multiple-dose vaccine represents full or partial vaccination. That is a major advantage given that for several countries such data is not available on a timely basis (see methodological annex here for a full discussion).
Note on Cuban vaccines and data: Cuba currently administers different protocols: Abdala (3-dose vaccine), Soberana 2 combined with Soberana Plus (considered a 3-dose vaccine for children) and Soberana Plus stand-alone (considered a 1-dose vaccine for those with prior COVID). Based on this distinction, we derive from the data published by the Cuban authorities that total doses under 1-dose protocol (Soberana Plus stand-alone) equal the difference between people fully vaccinated and people vaccinated with three shots. Total doses under 3-dose protocols are therefore total doses administered minus doses administered under the 1-dose protocol.
The distribution of vaccine doses across countries is described on the basis of data on the actual doses administered. The reasons why the numbers may be low can vary widely and include international vs domestic factors as well as supply versus demand factors. At this moment in time, however, the most likely reason for low numbers is related to international supply bottlenecks.
The charts that describe vaccine sufficiency for the priority group do not measure actual vaccination of the priority group. That is currently impossible to consistently assess at the global level given data gaps. Instead, it describes, on the basis of the size of the priority group and the number of doses administered, the extent to which the priority group could have been covered through the vaccination efforts up through the latest available data point.
The vaccine sufficiency measure would approximate actual vaccination if governments act as “benevolent social planners” interested in vaccinating their most vulnerable groups first. Even if that is the case, discrepancies may arise as it also requires common agreement about who the most vulnerable groups are. The charts assume that the vulnerable group consists of medical professionals under 60 and the entire 60+ population. In practice, governments around the world define their priority group in many different ways. The definition on this site is a minimal one in the interest of cross-country comparability and data availability.
How do we calculate the size of the priority group?
More refined estimates of the health workforce will undoubtedly be available at the country level. In the interest of building a global dataset we rely however on this method which has the advantage of imposing transparent assumptions on all countries in an equal way.
Several visualizations distinguish between the extensive and intensive margins of vaccination progress. The extensive margin captures the extent to which countries are participating in vaccination efforts. In the polar bar charts on this website, this can be observed in the circular progress bar, which shows the share of countries, by income group, that report nonzero vaccination data. The visualization also colors the country codes of countries in the outer circle according to whether positive vaccination data is being reported (blue means yes; grey means no).
The intensive margin measures vaccination progress within countries. In the polar bar visualizations, the outward-oriented bars capture the efforts of countries to raise the coverage ratio to the maximum of 200 (on the vertical axis).